Rotating

Description of your first forum.

Rotating

PostPosted by Lresources » Sat Apr 09, 2016 2:56 pm

I traced a deed onto a previous survey using BD. The bearings were different from the main drawing which was also the prev survey. I rotated the deed that I traced (deed was on a separate layer) using a common point and line. After I rotated it the bearings called out in the deed stayed the same. I would like them to change to the bearings of the prev survey which is the main drawing.
What Am I missing
Lresources
 
Posts: 4
Joined: Fri Jul 04, 2014 3:00 am

Re: Rotating

PostPosted by PHINESLS » Sun Apr 10, 2016 9:26 am

One way to get the rotated Bearings and distances to appear the way you want them, is to apply the BU command. That will label all the courses after your rotation. You can setup your Layers so you can manipulate your Drawing just the way you would like. Good Luck.

Regards,

Rusty
PHINESLS
 
Posts: 81
Joined: Sat Jun 21, 2014 6:13 pm
Location: Amagansett, New York


Return to General CADD Forum

Who is online

Users browsing this forum: No registered users and 0 guests